Fluke DSP-2000 Manual do Utilizador descarregar pdf (Página 81)

Running Individual Tests

When to Use a Remote Unit

4-5

1. If you are using a DSP-100 main unit as the remote, turn the remote unit’s

rotary switch to SMART REMOTE. If you are using a smart remote unit, turn

its rotary switch to ON.

2. Use a 2m patch cable of the correct impedance to connect the remote to the far

end of the cable link.

3. On Model DSP-100, remove any cable connected to the test tool’s BNC

connector.

4. Turn the rotary switch on the main unit to SINGLE TEST.

5. Use a 2m patch cable of the correct impedance to connect the test tool to the

near end of the cable link. On Model DSP-2000, connect to the CABLE TEST

jack.

6. Use U D to highlight the test you want to run.

7. Press E to start the highlighted test.

Note

If a remote is required for the test, but is not connected, the test tool

displays the message SCANNING FOR REMOTE and does not

run the test until a remote is connected.

If the calibration message appears, refer to “Calibrating the Test

Tool” in Chapter 6 for complete calibration instructions.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 195 196

Sem comentários

Fluke DSP-2000 Manual do Utilizador Página 81