Fluke Speaker Rev. 4 Manual do Utilizador descarregar pdf (Página 47)

Documenting Process Calibrator

Using Measure Mode

To measure temperature using an RTD input,

proceed as follows:

1. If necessary, press M for MEASURE mode.

2. Press ttwice so that Select RTD Type

shows.

3. Press u or d to select the desired RTD type.

4. Press e.

5. Press u or d to select a 2-, 3-, or 4- wire

connection.

6. Attach the RTD to input jacks as the display or

Figure 13 shows. Use the supplied jumper

between the mA

Ω

RTD MEAS low jack and the

V MEAS low jack as shown if you are using a 3-

wire connection.

7. Press e.

CAUTION

Do not force a dual banana plug between

any two jacks in the horizontal

orientation. (See the Figure.) Doing so

will damage the jacks. Use the supplied

jumper wire when needed for RTD

measurements. You can use a dual

banana plug in the vertical orientation.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 117 118

Sem comentários

Fluke Speaker Rev. 4 Manual do Utilizador Página 47